Can I lower the Temperature controller's hysteresis setting below 1?

The lowest resolution on the controller for the hysteresis is 1, however we have found that 1 degree is a very nominal difference in cellaring applications, and any setting less than 1 would cause the system to constantly cycle on and off.  That can be a detriment for many users because the chill water would be used up very quickly.  Furthermore, you could always reduce your set point by a degree to compensate for for the hysteresis if you didn't want your fermenting beer to exceed a predetermined threshold.  

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.